Aluminum I Beam Track

  • 6063-T5 Extruded Aluminum Track
  • Supplied in up to 20ft sections
  • 1”w x 2-1/2”h
  • Anodized Black
  • Custom curves available

Cut Sheet

 

Single Carrier

  • Neoprene-tired shielded ball bearing wheels riveted to formed steel body with swivel hook and trim chain
  • Plastic glide strips for reduction in noise & friction
  • Supplied with 2 rubber bumpers
    Carrier load rating at 12” center spacing: 8lbs

Cut Sheet

 

Master Carrier

  • 2 Neoprene-tired shielded ball bearing wheel assemblies with swivel hook and trim chain pivot on formed steel body
  • Supplied with 2 clamps for securing operating line
  • 1 pair required for overlapping tracks
    Carrier load rating at 12” center spacing: 8lbs

Cut Sheet

 

Double End Pulley

  • 4” Diameter Nylon sheaves grooved for 1/4” diameter rope with shielded ball bearings
  • Steel housing clamps to track
  • For use with bi-part and single draw track systems

Cut Sheet

 

Single End Pulley

  • 4” Diameter Nylon Sheave grooved for ¼” diameter rope with shielded ball bearings
  • Steel housing clamps to track
  • For use with bi-parting tracks.

Cut Sheet

 

Overlap Clamp

  • Steel formed bracket to offset tracks for bi-part
  • Black finish

Cut Sheet

 

Clamp Hanger

  • Formed steel brackets clamp to track
    Adjusts for various positions
  • Load rating for track varies based on install spacing

Cut Sheet

 

Splice

  • Aluminum plates align and bolt top track sections together
  • Track must be straight at joint.

Cut Sheet

 

Ceiling Hanger

  • Steel plate mounts flush to ceiling
  • Track clamps to bracket with offset clips
  • Adjustable mounting for various locations
  • Load rating for track varies based on install spacing

Cut Sheet

 

Outside Idler

  • Formed steel bracket with single ball bearing pulley for guiding of operation cord
  • Used along the outside of the single pulley end of track systems

 Cut Sheet

Single Spindle

  • Formed steel bracket with single ball bearing shaft for guiding of operation cord
  • Used along the inside single pulley end of track systems

Cut Sheet

 

Double Spindle

  • Formed steel housing contains two ball bearing guides for operating line to follow curve
  • Mount to inside and outside of curve on double end pulley section of track for single and bi-parting draw systems.

Cut Sheet

 

Wall Mount Track Bracket

  • Formed steel wall bracket for mounting of curtain track
  • Universal design for mounting in two directions
  • Mounting surface utilizes holes and slots for ease of installation
  • Brackets are powder coated in black finish
  • Load Rating: 150lbs
  • Custom colors available

 

Navigation Menu
Rigging Curtain Track Hardware I Beam Track